Ad blocker interference detected!
Wikia is a free-to-use site that makes money from advertising. We have a modified experience for viewers using ad blockers
Wikia is not accessible if you’ve made further modifications. Remove the custom ad blocker rule(s) and the page will load as expected.
The Filler is a machine added in version 1.6.5 to fill whole areas with blocks. It needs to be placed in front of a landmark to fill the area the landmarks are describing. (See the landmark page for how to use landmarks). It needs to be powered by a stirling engine or above. Fillers consume power (up to 100MJ/t in increments of 25MJ/block) whether they are activated or not.
- 2 x Dandelion Yellow
- 2 x Ink sacs
- 1 x Landmark
- 1 x Chest
- 1 x Crafting Table
- 2 x Gold Gears
Produces: 1 x Filler
see: Crafting Guide
Right-clicking on a filler brings up the filler interface. The top 3x3 area is for a filler pattern, and the resources area is where you place the materials to build with. There are 6 patterns that can be used. Patterns are made by placing Bricks and/or Glass in the top 3x3 area. When there is a valid pattern in the filler, the pattern icon will be visible in the small space in the top of the interface, and on the sides of the filler. The lights on top of the filler will also have turned green.
A filler will fill in water blocks, but will not fill in lava or oil blocks at all. Sand or gravel can be used in the filler to fill in lava or oil, due to gravity affecting them.
When the filler has finished its task, the lights will turn red again to indicate that it is finished. To start it working again on the same area, just remove and replace one of the bricks or glass from the pattern. A pickaxe is needed to retrieve a filler once placed.
Filler Patterns Edit
Fill pattern: Fills the area with blocks
Clear pattern: Removes all blocks in the area.
Stair pattern: Creates a staircase with 1 block high steps.
Box pattern: Walls, ceiling and floor.
Pyramid pattern: Creates a pyramid inside the area.
! NOTE ! In 1.7.2 + filler patterns are not needed
Note: clearing areas using the Flatten or Clear patterns
version - 3.3.x: Clearing is done bottom layer to top layer. Items dropped can be collected
version 3.4.x+: Clearing is done from top to bottom layer, items cannot be picked up in the first 1/2 second and vanish after a further half second. This change was made to stop the filler being used as a cheap quarry alternative. This can be disabled in the Buildcraft config file by setting the variable 'B:filler.destroy' to false.